Nice HOPP articulated arm operator kit for single-leaf gates, up to 2.4 m, up to 160 kg, 24 V

Nice HOPP is an arm operator for single swing gates with wide concrete or masonry posts. The distance from the post edge to the leaf's pivot axis can be up to 25 cm. The leaf can be up to 2.4 m wide at a weight of up to 160 kg, or weigh up to 250 kg at a width of up to 1.5 m. The 24 V DC motor handles 35 cycles per hour.

Functions

• the control unit and OXI radio receiver are built into the operator (HO7124),
• self-learning of the leaf travel, slowdown points and partial opening,
• photocells and control devices are connected with two wires via the BlueBus,
• ready for the PS124 backup battery or the SYKCE solar kit.

What to bear in mind before installation

• Stops – you set the end stops in the operator. We recommend a ground stop for closing; if the gate does not have one, you can also set the closing end stop in the operator.
• Installation dimensions – determine dimension A from the graph in the instructions according to dimension B and the opening angle.
• Environment – IP54 protection rating, operation at −20 to +55 °C.

For double swing gates there is the Nice HOPP for 2 leaves; you will find other types in the Articulated arm operators category. We install the operator in the Košice and Prešov regions; see the page.