Nice Wingo 2024/4024 operator kit for double-leaf gates, up to 4 m, 24 V

Nice Wingo is a linear operator for double swing gates of family homes with a total width of up to 4 m, i.e. with leaves up to 2 m. The motors have a 24 V DC power supply, so they also cope with more frequent opening. The control unit with a built-in radio receiver controls both leaves so that they open and close in the correct sequence.

Functions

• automatic learning of the end positions during setup,
• slowdown when opening and closing,
• obstacle detection,
• control with Nice transmitters on 433.92 MHz; the kit includes 2 INTI2 remotes.

Things to consider before installation

• Stops – in the open position the leaf is stopped by a stop built into the operator. In the closed position the gate must have a centre stop.
• Installation – the operators are mounted on the pillar and on the gate leaf, not in the ground. Check the installation dimensions in the instructions.
• Leaf infill – a solid infill increases the wind load. If you have solid leaves at the limit of the dimensions, get in touch with us.
• Safety – with automatic closing we recommend photocells. The kit with photocells is available as Wingo 2024 with EPM photocells.

For a gate up to 7 m with leaves up to 3.5 m choose the Wingo 3524 / 5024. If one operator fails, you can replace the separate Wingo 2024 motor.

In the Košice and Prešov regions we can also install the operator; more on the page.